Kit includes 49 bracelet blanks and bracelet bender You will receive forty-nine (49) bracelet blanks that are 16mm x 152mm, 16 gauge. Peel off blue film before stamping. It is there to prevent scratching.  To use Bracelet Bender: 1) Place one end of blank into the channel with the stamped side facing up (unless you're making a secret message bracelet). Firmly place your thumb against the end of the bracelet to secure it in place. 2) Using the palm of your hand, bend the bracelet half way around the bar until it forms a 90-degree angle, making sure not to over bend. 3) Remove. Place Straight end into channel, and repeat to finish shaping the bracelet. *To achieve a perfectly round cuff, continue with the Bracelet Bending Pliers, not included.