Therma rest Chair Kit lightweight kit to turn your mattress into a chair

Therma rest Chair Kit lightweight kit to turn your mattress into a chair- used once. 2 available. very clean. trace wear only. No stuff sacks. It's hard to deny yourself the added luxury and convenience of a chair when it only weighs 10 oz (290 g). This chair kiy creates a comfy place to rest and recover after a long day of hiking when combined with your thermarest. The sleeve edges fit thermarest pads. Ultralight Luxury: so compact, light and incredibly relaxing you may never travel without a chair again. Quick set-up; packs small when not in use. Versatile Design: Fits most thermarest mattresses • With side straps fully extended lay kit flat on the ground, pockets facing up • Insert valve end of partially inflated mattress into chair kit place on the air kit so that valve extends through valve opening in left-hand corner • Fold over the valve of top pocket to the same length as the seat pocket and tuck inside. Open valve and allow mattress to inflate, Secure the center strap across the width of the pad and tighten.Close valve. Tighten side straps to bring top pocket of chair kit to an upright position. Sit in chair and adjust side straps for comfort and support. Adjust air pressure if necessary. To remove mattress, extend side straps and pull mattress out of pockets. To sleep on mattress without removing it entirely from the chair kit, slip mattress out of seat pocket bottom only and unfold. stock photos are different models and for comparison purposes only